Table of Contents
Advertisement
Serial port
a. For Baud rate, select the baud rate used by the device to which you want to connect.
b. For Data bits, select the number of data bits used by the device to which you want to
connect.
c. For Parity, select the type of parity used by the device to which you want to connect.
d. For Stop bits, select the number of stop bits used by the device to which you want to
connect.
e. For Flow control, select the type of flow control used by the device to which you want to
connect.
6. Expand Data Framing Settings.
a. Click to expand Data Framing.
i. Click Enable to enable the data framing feature.
ii. For Maximum Frame Count, enter the maximum size of the packet. The default is
1024.
iii. For Idle Time, enter the length of time the device should wait before sending the
packet.
iv. For End Pattern, enter the end pattern. The packet is sent when this pattern is
received from the serial port.
v. Click Strip End Pattern if you want to remove the end pattern from the packet before
it is sent.
7. Expand UDP Serial Settings.
a. For Local port, enter the UDP port. The default is 4001 or serial port 1, 4002 for serial port
2, etc.
IX20 User Guide
Configure UDP serial mode
276
Advertisement
Table of Contents
