Table of Contents
Advertisement
Services
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config service multicast test)> src_interface
b. Set the interface. For example:
(config service multicast test)> add interface end
/network/interface/eth1
(config service multicast test)>
c. Repeat for each additional destination interface.
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Ethernet network bonding
The IX20 device supports bonding mode for the Ethernet network. This allows you to configure the
device so that Ethernet ports share one IP address. When both ports are being used, they act as one
Ethernet network port.
Required configuration items
Enable Ethernet bonding.
n
The mode, either:
n
Active-backup. Provides fault tolerance.
l
Round-robin. Provides load balancing as well as fault tolerance.
l
The Ethernet devices in the bonded pool.
n
Create a new network interface for the bonded Ethernet devices, and disable the any interfaces
n
associated with those Ethernet devices..
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
IX20 User Guide
Ethernet network bonding
765
Advertisement
Table of Contents
