Digi IX20W-PR User Manual page 386

c. For Subnet, type an IPv4 address and optional subnet mask, using the format IPv4_
d. Repeat to add additional subnets.
17. (Optional) For Maximum download speed, type the maximum download speed in kilobytes
per second (Kbps).
Note Setting the Maximum download speed to 0 means that the bandwidth is unlimited. This
can have an adverse effect on performance.
18. (Optional) For Maximum upload speed, type the maximum upload speed in kilobytes per
second (Kbps).
Note Setting the Maximum upload speed to 0 means that the bandwidth is unlimited. This
can have an adverse effect on performance.
19. (Optional) Click Debug to enable verbose logging to the system log.
20. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Create new access points for the hotspot.
You can also use existing access points for the hotspot. Access Points that are assigned to a
hotspot or to a bridge used by a hotspot cannot be used for any other purpose.
If more than one access point is being used by the hotspot, you must create a bridge that
includes the access points.
IX20 User Guide
address[/netmask], or the keyword any.
Hotspot
386