Table of Contents
Advertisement
Interfaces
8. Lightweight M2M support is enabled by default. Disable if you are using an AT&T SIM that
does not support AT&T lightweight M2M.
9. To add additional APNs, for Add APN, click and repeat the preceding instructions.
10. (Optional) To configure the device to bypass its preconfigured APN list and only use the
configured APNs, enable APN list only.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> network interface modem modem apn 0 apn value
(config)>
where value is the APN for the SIM card.
4. (Optional) To add additional APNs:
a. Use the add command to add a new APN entry. For example:
(config)> add network interface modem modem apn end
(config network interface modem modem apn 1)>
b. Set the value of the APN:
(config network interface modem modem apn 1)> apn value
(config network interface modem modem apn 1)>
where value is the APN for the SIM card.
5. (Optional) Set the IP version:
(config)> network interface modem modem apn 0 ip_version version
(config)>
IX20 User Guide
Wide Area Networks (WANs)
137
Advertisement
Table of Contents
