Table of Contents
Advertisement
Wi-Fi
4. For Channel, select the channel. Only channels appropriate for the band are displayed.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Determine the band for the radio:
(config)> network wifi radio phy0 band
2400mhz
(config)>
b. Set the channel for the Wi-Fi radio:
(config)> network wifi radio phy0 2400mhz channel value
(config)>
where value is:
n
n
IX20 User Guide
For 2.4 GHz:
1 through 11
l
auto
l
For 5 GHz:
36
l
40
l
44
l
48
l
auto
l
Configure the Wi-Fi radio's channel
314
Advertisement
Table of Contents
