Table of Contents
Advertisement
Interfaces
5. Modify the list of devices that are a part of the bridge. By default, the LAN bridge includes the
following devices:
n
Ethernet: ETH2
n
Wi-Fi access point: Digi AP
Note
The MACaddress of the bridge is taken from the first available device in the list.
a. To delete a device from the bridge, click the down arrow () next to the field label and
select Delete.
b. To add a device, for Add device, click and select the Device.
6. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when using multiple LANs on the same device, to prevent bridge loops and other
routing conflicts.
a. Click STP.
b. Click Enable.
c. For Forwarding delay, enter the number of seconds that the device will spend in each of
the listening and learning states before the bridge begins forwarding data. The default is 2
seconds.
7. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. The LAN bridge is enabled by default.
To disable:
n
(config)> network bridge eth2 enable false
(config)>
IX20 User Guide
Bridging
234
Advertisement
Table of Contents
