Digi IX20W-PR User Manual page 162

Interfaces
Parameters
---------------------------------------------------------------------
----------
dhcp_hostname
enable
metric
mgmt
mtu
type
use_dns
weight
Additional Configuration
---------------------------------------------------------------------
----------
connection_monitor
(config network interface my_wan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics
metrics.
8. (Optional) To configure 802.1x port based network access control:
Note The IX20 can function as an 802.1x authenticator; it does not function as an 802.1x
supplicant.
a. Enable the 802.1x authenticator on the IX20 device:
(config network interface my_wan)> 802_1x authentication enable true
(config network interface my_wan)>
b. Set the frequency period for reauthorization:
(config network interface my_wan)> 802_1x authentication reauth_period
value
(config network interface my_wan)>
where value is an integer between 0 and 86400. The default is 3600.
9. (Optional) Configure the MACaddress deny list.
Incoming packets will be dropped from any devices whose MACaddresses is included in the
MACaddress denylist.
IX20 User Guide
Current Value
false DHCP Hostname
true Enable
0 Metric
0 Management priority
1500 MTU
dhcpv6 Type
always Use DNS
10 Weight
Active recovery
Wide Area Networks (WANs)
for further information about
162