Table of Contents
Advertisement
Firewall
Packet filtering
By default, there are two preconfigured packet filtering rules:
Allow all outgoing traffic: Monitors traffic going to and from the IX20 device. The predefined
n
settings are intended to block unauthorized inbound traffic while providing an unrestricted
flow of outgoing data.
Allow Hotspot to External: Allows traffic that uses the hotspot firewall zone to be forwarded
n
to interfaces that use the External zone. You should not modify this packet filtering rule.
Configure packet filtering
Required configuration items
The action that the packet filtering rule will perform, either Accept, Reject, or Drop.
n
The source firewall zone: Packets originating from interfaces on this zone will be monitored by
n
this rule.
The destination firewall zone: Packets destined for interfaces on this zone will be accepted,
n
rejected, or dropped by this rule.
Additional configuration requirements
n
A label for the rule.
n
The IP version to be matched, either IPv4, IPv6, or Any.
n
The protocol to be matched, one of:
TCP
l
UDP
l
ICMP
l
ICMP6
l
Any
l
To configure a packet filtering rule:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
IX20 User Guide
Use Digi Remote Manager to view and manage your
Packet filtering
945
Advertisement
Table of Contents
