Table of Contents
Advertisement
Wi-Fi
e. For Long interval, type the number of seconds to wait between scans for access points,
when the signal strength from the access point to which the client is currently connected
is stronger than the Scan threshold.
f. Click to expand Scan frequencies list. You must add one or more frequency to scan:
i. Click to add a scan frequency.
ii. Select a frequency.
iii. Repeat for additional frequencies.
g. To add a channel, click Add Scan frequency and select the appropriate channel.
7. Click Apply to save the configuration and apply the change.
After you configure a Wi-Fi client, you must assign the Wi-Fi client to a WAN. See
(WANs) and Wireless Wide Area Networks (WWANs)
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new Wi-Fi client:
(config)> add network wifi client new_client
(config network wifi client new_client)>
New clients are enabled by default.
4. Configure the Wi-Fi network that the client will use:
a. Set the SSID of the access point that the client will use to connect to the Wi-Fi network:
(config network wifi client new_client)> ssid 0 ssid value
(config network wifi client new_client)>
where value is the SSID of the access point.
b. Set the encryption type for the access point:
(config network wifi client new_client)> ssid 0 encryption type value
(config network wifi client new_client)>
IX20 User Guide
Configure a Wi-Fi client and add client networks
for further information.
Wide Area Networks
353
Advertisement
Table of Contents
