Table of Contents
Advertisement
Routing
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable routing services:
(config)> network route service enable true
(config)>
4. Configure routing services that will be used:
a. Use the ? to display available routing services:
(config)> network route service ?
Routing services: Settings for dynamic routing services and protocols.
Parameters
---------------------------------------------------------------------
----------
enable
zone
Additional Configuration
---------------------------------------------------------------------
----------
bgp
isis
nhrp
ospfv2
ospfv3
rip
ripng
(config)>
b. Enable a routing service that will be used. For example, to enable the RIP service:
(config)> network route service rip enable true
(config)>
c. Complete the configuration of the routing service. For example, use the ? to view the
available parameters for the RIP service:
(config)> network route service rip ?
Parameters
IX20 User Guide
Current Value
true
Enable
dynamic_routes
Zone
BGP
IS-IS
NHRP
OSPFv2
OSPFv3
RIP
RIPng
Current Value
IP routing
445
Advertisement
Table of Contents
