Digi IX20W-PR User Manual page 326

Wi-Fi
n none: No encryption is used.
n owe: Uses WPA3 Enhanced Open, which uses Opportunistic Wireless Encryption (OWE)
technology to provide encryption for Wi-Fi networks that do not use password
protection.
Note
have WPA3 capabilities.
7. (Optional) Determine whether to prevent clients that are connected to this access point from
communicating with each other:
(config)> network wifi ap digi_ap isolate_client true
(config)>
See Isolate Wi-Fi clients
access points from communicating with each other.
8. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
(config)> network wifi ap digi_ap encryption group_rekey value
(config)>
where value is any number of days, hours, minutes, or seconds, and takes the format number
{d|h|m|s}.
For example, to set group rekey interval to ten minutes, enter either 10m or 600s:
(config)> network wireless ap digi_ap encryption group_rekey 600s
(config)>
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Network (LAN)
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
Only select owe if you know that all Wi-Fi clients connecting to this device will
for information about how to prevent clients connected to different
and Configure a bridge for more information.
Configure an open Wi-Fi access point
Configure a Local Area
326