Table of Contents
Advertisement
Interfaces
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Bridges.
4. For Add Bridge, type a name for the bridge and click .
5. Bridges are enabled by default. To disable, toggle off Enable.
6. For Bridge type, select Standard.
See
Create a VLAN using switchport mode
7. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when using multiple LANs on the same device, to prevent bridge loops and other
routing conflicts.
a. Click STP.
b. Click Enable.
c. For Forwarding delay, enter the number of seconds that the device will spend in each of
the listening and learning states before the bridge begins forwarding data. The default is 2
seconds.
8. (Optional) Enable Rapid Spanning Tree Protocol (RSTP) for faster response to topology
changes on the network.
a. Click RSTP to enable.
b. For Hello Time, enter the number of seconds between bridge protocol units (BPDUs) sent
on a port. The default is 2 seconds.
c. For Max Age, enter the maximum number of seconds before a bridge port saves its BDPU
configuration. The default is 20 seconds.
IX20 User Guide
Use Digi Remote Manager to view and manage your
for information about switchport bridging.
Bridging
237
Advertisement
Table of Contents
