Verify Your Web Filtering Configuration - Digi IX20W-PR User Manual

Firewall
b. Set the web filter service type to manual:
(config)> firewall web-filter service manual
(config)>
c. Add the first DNS server:
i. Add the server:
(config)> add firewall web-filter server end
(config firewall web-filter server 0)>
ii. Set the server's IP address:
(config firewall web-filter server 0)> ip 208.67.222.220
(config firewall web-filter server 0)>
d. Add the second DNS server:
i. Move back one node in the configuration tree:
(config firewall web-filter server 0)> ..
(config firewall web-filter server)>
ii. Add the server:
(config firewall web-filter server)> add end
(config firewall web-filter server 1)>
iii. Set the server's IP address:
(config firewall web-filter server 1)> ip 208.67.222.222
(config firewall web-filter server 0)>
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Verify your web filtering configuration

If your web filtering implementation has the service set to Cisco Umbrella, or if it is configured to use
manual DNS servers and uses the Cisco open DNS servers, you can verify the web filtering
implementation by using the Cisco test site www.internetbadguys.com.
To verify the implementation:

Web
This procedure assumes you have already configured web filtering to use either Cisco Umbrella or the
Cisco open DNS servers.
IX20 User Guide
Web filtering
978