Table of Contents
Advertisement
Interfaces
3. Configure active recovery on ETH1:
a. Click Network > Interface > ETH1 > SureLink.
b. For Test interval, type 10s.
c. Click to expand Tests.
d. Disable the default DNS test:
i. Click to expand the default DNS configured test.
ii. Click to toggle off Enable.
e. Click to add a new test.
f. For Test type, select Ping test.
g. For Ping host, type 43.66.93.111.
h. For Ping payload size, type 256.
4. Repeat the above step for Modem to enable SureLink on that interface.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX20 User Guide
Wide Area Networks (WANs)
127
Advertisement
Table of Contents
