Table of Contents
Advertisement
Digi IX20 hardware setup
Install SIM cards in the Plug-in LTE modem
There is a label on the bottom of the CORE modem that indicates the plug-in modem IMEI number.
The modem is referred to as 1002-CM.
To install SIM cards:
1. Identify the SIM 1 and SIM 2 slots on the CORE modem. If using only one SIM card, insert it into
SIM 1. A second SIM may be inserted into slot SIM 2 for an alternate wireless carrier.
2. For high-vibration environments, apply a thin layer of dielectric grease to the SIM contacts.
Note
If the IX20 device is used in an environment with high vibration levels, SIM card contact
fretting may cause unexpected SIM card failures. To protect the SIM cards, Digi strongly
recommends that you apply a thin layer of dielectric grease to the SIM contacts prior to
installing the SIM cards. See
3. Insert the SIM cards into the CORE modem.
4. On the IX20 back panel, remove the CORE modem cover by loosening the cover plate thumb
screw and removing the cover plate.
5. With the antennas SMA connectors pointing outward, slide the CORE modem into the IX20
device. A clicking sound will indicate it is properly inserted.
6. Secure the CORE modem with the supplied anchor screw. Use either a Philips #0 or a Torx T10
driver. Torque screw to 2 in lbs (225 mN m) maximum.
IX20 User Guide
Install SIM cards in the Plug-in LTEmodem
Apply Dielectric Grease over SIM Contacts
for instructions.
37
Advertisement
Table of Contents
