Digi IX20W-PR User Manual page 371

4. Change the default SSID, Digi Hotspot, to your preferred value.
5. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change the SSID for digi_hotspot_ap to your preferred value:
(config)> network wifi ap digi_hotspot_ap ssid value
where value is a string of 1 to 32 characters. If the value contains spaces, enclose in quote
marks (").
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Change the default hotspot IP address and subnet
Required configuration items
n Enable default hotspot configuration. See
instructions.
n An IP address and subnet for the hotspot.
IX20 User Guide
Enable hotspot using the default configuration
Hotspot
for
371