Table of Contents
Advertisement
User authentication
10. (Optional) Enable users that belong to this group to query the device for Nagios monitoring by
checking the box next to Nagios access.
11. (Optional) Enable users that belong to this group to access the Wi-Fi scanning service by
checking the box next to Wi-Fi scanner access.
12. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the add auth group command to add a new authentication. For example, to add a group
named test:
(config)> add auth group test
(config auth group test)>
4. Enable access rights for the group:
n
Admin access:
(config auth group test)> acl admin enable true
(config)>
n
Set the access level for Admin access:
(config)> auth group admin acl admin level value
(config)>
where value is either:
full: provides users of this group with the ability to manage the IX20 device by using
l
the WebUI or the Admin CLI.
read-only: provides users of this group with read-only access to the WebUI and
l
Admin CLI.
The default is full.
n
Shell access:
(config auth group test)> acl shell enable true
(config)>
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
IX20 User Guide
for more information about the Allow shell parameter.
Authentication groups
Disable
877
Advertisement
Table of Contents
