Table of Contents
Advertisement
Services
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the mDNS service:
(config)> service mdns enable true
(config)>
4. Configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service mdns acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the mDNS service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add service mdns acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the mDNS service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX20 device:
(config)> add service mdns acl interface end value
(config)>
Where value is an interface defined on your device.
IX20 User Guide
Display a list of available interfaces:
Enable service discovery (mDNS)
772
Advertisement
Table of Contents
