Table of Contents
Advertisement
Revision
Date
P
July 2023
IX20 User Guide
Description
Redesigned Surelink configuration settings.
l
Added show surelink state Admin CLI command
l
to display the overall pass/fail status of enabled
Surelink tests.
WAN bonding
n
Added options for WAN bonding configuration to
l
set modes for the bonded tunnel and for each
bonded interface.
Added new show wan-bonding Admin CLI
l
command.
New configuration settings for LXCcontainers:
n
Start on boot to configure the container to start
l
when the system boots.
Restart timeout to configure the container to
l
restart if it stops.
Optional parameters to include optional
l
parameters for the container.
Mounted directories to setup shared directories
l
between the host filesystem and the container.
n
Added a AT&T LWM2M support setting to enable or
disable AT&T lightweight M2M on cellular modems.
n
VPN:
DMVPN phase 1 spoke support with NHRP or mGRE,
l
including compatibility with Cisco DMVPN hubs.
Added support for SHA2 ciphers for IKEv2 IPsec
l
tunnels.
n
Disabled mDNS by default for improved cellular
performance.
n
If the device has a configured System > Name, it is
now displayed on the Dashboard.
Release of DigiIX20 firmware version 23.6:
Serial port options:
n
For PPP Dial-in mode, added the Default Route
l
option to control whether a default route gets
added for the PPP interface.
Documented the new Modem emulator mode,
l
which allows serial ports to act as a dial-up modem
emulator for handling incoming AT dial-ins.
n
Advanced Watchdog options:
Added System > Advanced Watchdog options to
l
all devices.
3
Advertisement
Table of Contents
