Table of Contents
Advertisement
Interfaces
4. Set the interface type to passthrough:
(config network interface ip_passthrough_interface)> type passthrough
(config network interface ip_passthrough_interface)>
5. Set the firewall zone to internal:
(config network interface ip_passthrough_interface)> zone internal
(config network interface ip_passthrough_interface)>
6. Select an Ethernet device or a Wi-Fi access point for this interface:
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_wan)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan
/network/wireless/ap/digi_ap
/network/wireless/ap/digi_hotspot_ap
Current value:
(config network interface ip_passthrough_interface)> device
b. Set the device for the interface:
(config network interface ip_passthrough_interface)> device device
(config network interface my_wan)>
7. Set passthrough options
8. Configure IPv4 settings:
n
IPv4 support is enabled by default. To disable:
(config network interface ip_passthrough_interface)> ipv4 enable
false
(config network interface ip_passthrough_interface)>
a. Set the IP metric:
(config network interface ip_passthrough_interface)> ipv4 metric num
(config network interface ip_passthrough_interface)>
b. Set the relative weight for default routes associated with this interface. For multiple active
interfaces with the same metric, the weight is used to load balance traffic to the interfaces.
IX20 User Guide
Local Area Networks (LANs)
224
Advertisement
Table of Contents
