Digi IX20W-PR User Manual page 408


Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show hotspot
> show hotspot
Hotspot
-----------
hotspot
new_hotspot
>
3. Enter the show hotspot name hotspot_name command at the Admin CLI prompt to display
information about clients connected to a specific hotspot:
> show hotspot name hotspot
MAC Address
Idle/max sec
-----------------
----- ------------------
8C-2D-2D-C8-41-AA
0/0
E5-8A-FC-D3-DC-7E
0/0
>
4. Enter the show hotspot ip ip_address command at the Admin CLI prompt to display
information about clients connected to a specific hotspot:
> show hotspot ip hotspot 10.1.0.101
MAC Address
Idle/max sec
-----------------
----- ------------------
8C-2D-2D-C8-41-AA
IX20 User Guide
command at the Admin CLI prompt:
Enabled Status Device
------- ------ --------------
true up hotspot_bridge
false down new_hotspot_ap
IP Address Auth
%/max up bandwidth %/max down bandwidth
---------- ----
--------------------
10.1.0.101 yes
0/0
10.1.0.100 no
0/0
IP Address Auth
%/max up bandwidth %/max down bandwidth
---------- ----
--------------------
10.1.0.101 yes
Username Duration/max sec
-------- ----------------
mariev 0/0
- 0/0
Username Duration/max sec
-------- ----------------
mariev 0/0
Hotspot
-------
0/0
0/0
-------
0/0
408