Table of Contents
Advertisement
Virtual Private Networks (VPN)
n
both: Add a sequence number to each outgoing packet, and reorder packets if they are
received out of order.
The default is none.
16. Save the configuration and apply the change
(config)> save
Configuration saved.
>
17. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show L2TPV3 tunnel status
Web
Log into the IX20 WebUI as a user with full Admin access rights.
1. On the menu, select Status. Under VPN, select L2TPv3 Ethernet.
The L2TPv3 Ethernet page appears.
2. To view configuration details about an L2TPV3 tunnel, click the (configuration) icon in the
upper right of the tunnel's status pane.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured L2TPv3 Ethernet tunnels, type the following at the
prompt:
> show l2tpeth
Tunnel Session
-----------------
test/session/test
>
3. To display details about a specific tunnel:
> show l2tpeth name /vpn/l2tpeth/test/session/test
test/session/test Tunnel Session Status
---------------------------------------
Enabled
Status
IX20 User Guide
Enabled
Device
-------
------------
true
le_test_test
: true
: up
L2TPv3 Ethernet
Status
------
up
632
Advertisement
Table of Contents
