Table of Contents
Advertisement
Routing
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create the route policy:
a. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
b. Set the label that will be used to identify this route policy:
(config network route policy 0)> label "Domain-based policy"
(config network route policy 0)>
c. Set the interface:
(config network route policy 0)> interface /network/interface/eth1
(config network route policy 0)>
d. Leave the source address type at the default of zone.
e. Leave the source address zone at the default of any.
f. Configure the destination address:
i. Set the destination to use a domain:
(config network route policy 0)> dst type domain
(config network route policy 0)>
IX20 User Guide
IP routing
436
Advertisement
Table of Contents
