Table of Contents
Advertisement
Serial port
11. Expand Logging Settings to configure logging for this serial port.
a. To enable logging, click to toggle on Enable.
b. In the Log file name field, enter a descriptive name for the log file.
c. For Log file size, type the size of the log file. When the log file reaches the size limit, the
current file is saved and a new file is created. The default is 65536 bytes.
d. From the Type of data to log list box, specify the type of data that should be saved.
n
n
n
n
e. If you want to log the time at which date was received or transmitted, click the
Timestamps toggle to Enable.
f. If you want to log the data as hexadecimal values, click the Hexadecimal toggle to
Enable.
Note
You can review the message log in the Serial Port Log page. See
port message
12. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Serial ports is enabled by default. To disable:
(config)> serial port_number enable false
(config)>
Command line examples in this section will use port1 for the serial port. However, any port
number can be used.
4. Set the mode:
(config)> serial port1 mode remoteaccess
(config)>
5. (Optional) Set a label that will be used when referring to this port.
(config)>serial port1 label label
(config)>
IX20 User Guide
Received
Transmitted
Both
Both with arrows. This is the default.
log.
Configure Remote Access mode
Review the serial
254
Advertisement
Table of Contents
