Table of Contents
Advertisement
Serial port
(config)>serial port1 service ssh nodelay true
(config)>
v. (Optional) Configure access control:
IX20 User Guide
n
To limit access to specified IPv4 addresses and networks:
(config)> add serial port1 service ssh acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add serial port1 service ssh acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX20
device:
(config)> add serial port1 service ssh acl interface end
value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
eth1
eth2
loopback
modem
Configure Remote Access mode
Default IP
Default Link-local IP
ETH1
ETH2
Loopback
Modem
259
Advertisement
Table of Contents
