Digi IX20W-PR User Manual page 395

2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new hotspot
4. Set the authentication mode to local-shared-password:
(config)> network hotspot hotspot_name auth local-shared-password
(config)>
5. Set the password that all users will be required to enter to authentication with the hotspot:
(config)> network hotspot hotspot_name local_shared_password password
(config)>
6. Save the configuration and apply the change
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the hotspot to use RADIUS shared password authentication
RADIUS shared password authentication requires each user to enter a password. This password is
validated by an external RADIUS server, and the password is the same for all users.
Create a user on the RADIUS server with the username guest. The password assigned at the RADIUS
server for the user guest is the shared password that your hotspot users should enter to authenticate
to the hotspot via the RADIUS server.
By default, the router redirects unauthenticated users to the HTML authentication page located on the
router at etc/config/hotspot/password.html. You can customize the authentication page as needed,
or host an authentication page on a remote server. See
information.
Required configuration items
Create a new hotspot
n
Select RADIUS shared password authentication.
n
IP address or hostname of the primary RADIUS server.
n
A user on the RADIUS server with the username guest.
n
RADIUS server secret.
n
RADIUS NAS ID.
n
Domain name or subnet of the RADIUS server included in the "white list" of servers that
n
unauthenticated hotspot clients can access.
IX20 User Guide
or Enable hotspot using the default
or Enable hotspot using the default
configuration.
Customize the hotspot login page
configuration.
Hotspot
for further
395