Table of Contents
Advertisement
Services
The WAN bonding web interface can be used to view detailed WAN bonding statistics and to
fine-tune the WAN bonding process, and is accessed via a web browser at http://ip-
address:8088, where ip-address is the IP address of the local IX20 device.
(config)> network sdwan wan_bonding web_interface password password
(config)>
11. Save the configuration and apply the change
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show WAN bonding status and statistics
You can display status and statistics for WAN bonding. This command is available only at the Admin
CLI.
Web
Log into the IX20 WebUI as a user with full Admin access rights.
1. On the main menu, click Status.
2. Under Networking, click WAN bonding.
The current status of the device's bonding interfaces is displayed.
Command line
Show WAN bonding information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show wan-bonding
> show wan-bonding
WAN Bonding Status
------------------
Status
Server Address
Tunnel Username
Tunnel Address
WAN Bonded Interfaces
---------------------
IX20 User Guide
command at the system prompt:
: Connected
: 133.183.203.237
: test1
: 146.78.40.226
WAN bonding
692
Advertisement
Table of Contents
