Table of Contents
Advertisement
Wi-Fi
3. Click Network > WiFi.
4. For Frequency band, select either 2.4 GHz or 5 GHz.
5. For Access point mode, select the appropriate mode. Only modes appropriate for the selected
band are displayed.
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set channel for the radio:
a. Set the band for the radio:
(config)> network wifi radio phy0 band value
(config)>
where value is either 2400mhz or 5000mhz.
b. Set the mode for the Wi-Fi radio. For example:
n
IX20 User Guide
If the Wi-Fi radio has a band of 2400mhz:
(config)> network wifi radio phy0 2400mhz mode value
(config)>
where value is one of b, bg, bgn, g, gn, or n.
Configure the Wi-Fi radio's band and protocol
318
Advertisement
Table of Contents
