Digi IX20W-PR User Manual page 690

Services
4. Set the hostname or IPv4 address of the external server hosting the WAN bonding service:
(config)> network sdwan wan_bonding hostname hostname-or-IPv4-address
(config)>
5. (Optional) Set the port number that the external server uses for the WAN bonding connection:
(config)> network sdwan wan_bonding host_port port
(config)>
Allowed values are any port number, or the keyword any. The default is 443.
6. Set the username and password to authenticate with the WAN bonding service:
(config)> network sdwan wan_bonding username username
(config)> network sdwan wan_bonding password password
(config)>
7. Set the firewall zone for this interface. To treat the interface as a normal WAN interface, this
would be left at the default of external.
a. Use the ? to determine available zones:
(config)> network sdwan wan_bonding zone ?
Zone: The zone for the new bonded interface. To treat the interface as
a typical
WAN interface, this should be set to External.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Default value: external
Current value: external
(config)>
b. Set the zone:
(config)> network sdwan wan_bonding zone zone
(config)>
8. Configure the device's WAN interfaces that will be bonded:
a. Add the first interface:
(config)> add network sdwan wan_bonding interfaces end
(config network sdwan wan_bonding interfaces 0)>
IX20 User Guide
WAN bonding
690