Table of Contents
Advertisement
User authentication
8. Add a TACACS+ server:
a. Add the server:
(config)> add auth tacacs+ server end
(config auth tacacs+ server 0)>
b. Enter the TACACS+ server's IP address or hostname:
(config auth tacacs+ server 0)> hostname hostname|ip-address
(config auth tacacs+ server 0)>
c. (Optional) Change the default port setting to the appropriate port:
(config auth tacacs+ server 0)> port port
(config auth tacacs+ server 0)>
d. (Optional) Repeat the above steps to add additional TACACS+ servers.
9. Add TACACS+ to the authentication methods. Authentication methods are attempted in the
order they are listed until the first successful authentication result is returned. This example
will add TACACS+ to the end of the list. See
adding methods to the beginning or middle of the list.
(config)> add auth method end tacacs+
(config)>
10. Save the configuration and apply the change
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
Terminal Access Controller Access-Control System Plus (TACACS+)
User authentication methods
for information about
900
Advertisement
Table of Contents
