Signal Quality Indicators; Ethernet Link And Activity - Digi IX20W-PR User Manual

Digi IX20 hardware reference
Alternating Red/yellow (or orange)
Upgrading firmware.
1. Or an unknown type of cellular network.

Signal quality indicators

LEDs labeled 1 through 5 Indicate the cellular service quality level.
Signal bars
The weighted dBm measurements are negative numbers, meaning values closer to zero denote a
larger number. For example, a -85 is a better signal than -90.
Note See Signal quality bars explained
calculated and subsequently displayed via the LED indicators.

Ethernet Link and Activity

The LEDs on the WAN/ETH1 and ETH2 ports indicate that the Ethernet network interface is up and
there is activity on the network interface.
Left LED (on top of port connector)
n Off: No Ethernet link detected.
n Solid amber: Ethernet link detected.
n Blinking amber: Indicates Ethernet traffic.
Right LED (on top of port connector)
IX20 User Guide
WARNING! DO NOT POWEROFF DURINGFIRMWARE UPGRADE.
Weighted dBm
-113 to -99
-98 to -87
-86 to -76
-75 to -64
-63 to -51
for more information regarding how signal strength is
Signal strength %
0% to 23%
24% to 42%
43% to 61%
62% to 80%
81% to 100%
IX20 LEDs
Quality
Bad
Marginal
OK
Good
Excellent
30