Digi IX20W-PR User Manual page 379

a. Click Network > Bridges > LAN > Devices.
b. Click the ... menu icon next to the Ethernet: device entry and select Delete.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Display a list of available devices by using the tab autocomplete feature:
(config)> add network bridge hotspot_bridge device end /network/<tab>
/network/device/eth1
/network/device/loopback
/network/bridge/lan
/network/wifi/ap/digi_hotspot_ap
(config)> add network bridge hotspot_bridge device end /network/
4. Add a new device. For example, to add the device:
(config)> add network bridge hotspot_bridge device end
/network/device/eth
(config)>
By default, the ETH1 device is configured as the device for the ETH1 interface, and ETH2
configured as device in the LAN bridge, which is used by the ETH2 interface. As a result, when
you add an Ethernet port to the hotspot, you may need to reconfigure the Ethernet port
configuration for other interfaces. For example, to remove the port from the LAN bridge:
a. Display the current LAN bridge configuration:
(config)> show network bridge lan device
0 /network/device/eth2
1 /network/wifi/ap/digi_ap
(config)>
IX20 User Guide
/network/device/eth2
/network/bridge/hotspot_bridge
/network/wifi/ap/digi_ap
Hotspot
379