Table of Contents
Advertisement
Wi-Fi
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > WiFi.
4. For Frequency band, select 5 GHz.
5. Click to enable DFS Client Support.
Note
When DFS Client Support is enabled, any enabled access points that use this radio will
not be started and cannot be used as access points.
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Set the band for the radio to 5 GHz:
(config)> network wifi radio phy0 band 5000mhz
(config)>
IX20 User Guide
Configure the Wi-Fi radio to support DFSchannels in client mode
316
Advertisement
Table of Contents
