Digi IX20W-PR User Manual page 190

Interfaces
6. (Optional) Configure IPv6 settings:
a. Click to expand IPv6.
b. For Type, select IPv6 prefix delegation.
7. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the zone to internal:
(config)> network interface eth1 zone internal
(config)>
4. Configure IPv4 settings:
a. Set the type to static:
(config)> network interface eth1 ipv4 type static
(config)>
b. Set the address IPv4 address and netmask, using the format IPv4_address/netmask, for
example:
(config)> network interface eth1 ipv4 address 192.168.3.1/24
(config)>
c. Enable the DHCP server:
(config)> network interface eth1 ipv4 dhcp_server enable true
(config)>
d. Disable SureLink:
(config)> network interface eth1 ipv4 surelink enable false
(config)>
5. (Optional) Configure IPv6:
a. Set the type to prefix_delegation:
(config)> network interface eth1 ipv6 type prefix_delegation
(config)>
IX20 User Guide
Local Area Networks (LANs)
190