Table of Contents
Advertisement
Services
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service ssh acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the SSH service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add service ssh acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SSH service.
l
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX20 device:
(config)> add service ssh acl interface end value
(config)>
Where value is an interface defined on your device.
IX20 User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
eth1
eth2
Default IP
Default Link-local IP
ETH1
ETH2
Configure SSH access
663
Advertisement
Table of Contents
