Example Performance Test Using Iperf3 - Digi IX20W-PR User Manual

Services
Repeat this step to include additional firewall zones.
6. Save the configuration and apply the change
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Example performance test using iPerf3

On a remote host with Iperf3 installed, enter the following command:
$ iperf3 -c device_ip
where device_ip is the IP address of the IX20 device. For example:
$ iperf3 -c 192.168.2.1
Connecting to host 192.168.2.1, port 5201
[ 4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201
[ ID] Interval
[ 4] 0.00-1.00
[ 4] 1.00-2.00
[ 4] 2.00-3.00
[ 4] 3.00-4.00
[ 4] 4.00-5.00
[ 4] 5.00-6.00
[ 4] 6.00-7.00
[ 4] 7.00-8.00
IX20 User Guide
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config)>
Transfer
sec 26.7 MBytes
sec 28.4 MBytes
sec 29.8 MBytes
sec 31.2 MBytes
sec 32.1 MBytes
sec 32.5 MBytes
sec 33.9 MBytes
sec 33.7 MBytes
Configure the ping responder service
Bandwidth Retr
224 Mbits/sec 8
238 Mbits/sec 29
250 Mbits/sec 0
262 Mbits/sec 0
269 Mbits/sec 0
273 Mbits/sec 0
284 Mbits/sec 0
282 Mbits/sec 0
Cwnd
2.68 MBytes
1.39 MBytes
1.46 MBytes
1.52 MBytes
1.56 MBytes
1.58 MBytes
1.60 MBytes
1.60 MBytes
794