Table of Contents
Advertisement
Routing
b. Set the zone. For example:
See
interface: Matches the source IP address to the selected interface's network address.
n
Set the interface:
a. Use the ? to determine available interfaces:
b. Set the interface. For example:
n
address: Matches the source IPv4 address to the specified IP address or network. Set
the address that will be matched:
IX20 User Guide
Zone: Match the IP address to the specified firewall zone.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> src zone
(config network route policy 0)> src zone external
(config network route policy 0)>
Firewall configuration
for more information about firewall zones.
(config network route policy 0)> src interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network route policy 0)> src interface
(config network route policy 0)> src interface
/network/interface/eth1
(config network route policy 0)>
IP routing
428
Advertisement
Table of Contents
