Digi IX20W-PR User Manual page 239

Interfaces
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan
/network/wireless/ap/digi_ap
/network/wireless/ap/digi_hotspot_ap
Default value: /network/bridge/lan
Current value: /network/bridge/lan
(config network bridge my_bridge)>
b. Add the appropriate device. For example, to add the Digi AP Wi-Fi access point:
(config network bridge my_bridge)> add device end
/network/wireless/ap/digi_ap
(config)>
Note The MACaddress of the bridge is taken from the first available device in the list.
7. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when using multiple LANs on the same device, to prevent bridge loops and other
routing conflicts.
a. Enable STP:
(config network bridge my_bridge)> stp enable true
b. Set the number of seconds that the device will spend in each of the listening and learning
states before the bridge begins forwarding data:
(config network bridge my_bridge)> stp forward_delay num
(config)>
The default is 2 seconds.
8. (Optional) Enable Rapid Spanning Tree Protocol (RSTP) for faster response to topology
changes on the network.
(config network bridge my_bridge)> rstp enable true
9. Save the configuration and apply the change
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
Bridging
239