Digi IX20W-PR User Manual page 354

Wi-Fi
where value is the type of encryption used by the access point. Allowed values are:
n
n
n
n
n
n
n
n
Note When Primary Responder mode is enabled, the WPA personal security mode is not
available, and the psk and mixed psk options are not available. For more information
about Primary Responder mode, see
and Primary Responder
c. If the type of encryption is set to:
n
n
IX20 User Guide
none: no encryption.
owe: WPA3 Enhanced Open, which uses Opportunistic Wireless Encryption (OWE)
technology to provide encryption for Wi-Fi networks that do not use password
protection.
psk: WPA personal encryption.
mixedpsk: Uses both WPA and WPA2 personal encryption.
psk2: WPA2 personal encryption.
psk2sae: Uses WPA2-PSK/WPA3-AES mixed mode.
sae: Uses WPA3 Personal mode.
wpa2: WPA2 enterprise encryption.
mode.
psk, mixedpsk, psk2, psk2sae, or sae, set the password that the client will use to
connect to the access point:
(config network wifi client new_client)> ssid 0 encryption key_
psk2 password
(config network wifi client new_client)>
Note If you need to configure a Wi-Fi passphrase with any non-printable ASCII
characters, you can use the wpa_passphrase tool to generate the appropriate pre-
shared key. The wpa_passphrase command is available in the shell console of a
DAL OS Digi device. For details about the command, see the
command.
wpa2:
i. Set the Extensible Authentication Protocol (EAP):
(config network wifi client new_client)> ssid 0 encryption
eap_type value
(config network wifi client new_client)>
where value is one of:
peap: Username/password authentication. If peap is set:
l
i. Set the username:
(config network wifi client new_client)> ssid 0
encryption id_wpa2 username
(config network wifi client new_client)>
Configure a Wi-Fi client and add client networks
Differences between standard firmware operation
wpa_passphrase Linux
354