Table of Contents
Advertisement
Wi-Fi
8. For Encryption, select one of the following:
n
WPA Personal (PSK): All Wi-Fi clients must support WPA to be able to authenticate.
Note
available. For more information about Primary Responder mode, see
between standard firmware operation and Primary Responder
WPA/WPA2 Personal (PSK): Wi-Fi clients that support WPA and WPA2 are able to
n
authenticate.
Note
available. For more information about Primary Responder mode, see
between standard firmware operation and Primary Responder
WPA2 Personal (PSK): All Wi-Fi clients must support WPA2 to be able to authenticate.
n
WPA2-PSK/WPA3-SAE mixed mode: Wi-Fi clients that support WPA2 and WPA3 are
n
able to authenticate.
WPA3 Personal (SAE): All Wi-Fi clients must support WPA3 to be able to authenticate.
n
Note
this device will have WPA3 capabilities.
9. For Pre-shared key, enter the password that clients will use when connecting to the access
point.
Note
If you need to configure a Wi-Fi passphrase with any non-printable ASCII characters, you
can use the wpa_passphrase tool to generate the appropriate pre-shared key. The wpa_
passphrase command is available in the shell console of a DAL OS Digi device. For details
about the command, see the
10. (Optional) For Group rekey interval, type the amount of time to wait before changing the
group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
Allowed values are any number of days, hours, minutes, or seconds, and take the format
number{d|h|m|s}.
For example, to set Group rekey interval to ten minutes, enter 10m or 600s.
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
11. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Network (LAN)
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
12. Click Apply to save the configuration and apply the change.
Command line
IX20 User Guide
When Primary Responder mode is enabled, the WPA personal security mode is not
When Primary Responder mode is enabled, the WPA personal security mode is not
Only select WPA3 Personal (SAE) if you know that all Wi-Fi clients connecting to
wpa_passphrase Linux
and
Configure a bridge
for more information.
Configure a Wi-Fi access point with personal security
command.
Configure a Local Area
Differences
mode.
Differences
mode.
329
Advertisement
Table of Contents
