Digi IX20W-PR User Manual page 261

Serial port
where int is any integer between 1 and 65535. The default is 4001.
iii. Enable TCP keep-alive messages:
(config)>serial port1 service tcp keepalive true
(config)>
iv. Set the option that initiates the connection:
(config)>serial port1 service tcp conn_type value
(config)>
where value is one of:
The default is tls.
v. Enable TCP nodelay messages:
(config)>serial port1 service tcp nodelay true
(config)>
vi. (Optional) Configure access control:
IX20 User Guide
n tcp
n tls
n tls_auth
n To limit access to specified IPv4 addresses and networks:
(config)> add serial port1 service tcp acl address end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add serial port1 service tcp acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX20
n
device:
Configure Remote Access mode
261