Set Up The Ix20 For Python Development; Create And Test A Python Application - Digi IX20W-PR User Manual

Applications

Set up the IX20 for Python development

1. Access the IX20 local web interface
a. Use an Ethernet cable to connect the IX20 to your local laptop or PC.
The factory default IP address is 192.168.2.1
b. Log into the IX20 WebUI as a user with full admin access rights.
The default user name is admin and the default password is the unique password printed
on the label packaged with your device.
2. Go to the Configuration window
a. On the menu, click System.
b. Under Configuration, click Device Configuration. The Configuration window displays.
3. Enable service discovery (mDNS)
a. Click Services > Service Discovery (mDNS).
b. Enable the mDNS service.
Note For more information, see
4. Configure SSH access
a. Click Services > SSH.
b. Click Enable.
Note For more information, see the following topics:
authentication, and
5. Enable shell access
a. Click Authentication > Groups > admin.
b. Click the Interactive shell access option.
c. If this option is not displayed, see
6. Click Apply to save the configuration and apply the changes.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.

Create and test a Python application

To develop a Python application for the IX20:
1. Set up the IX20 for Python
2. Create and test your application with:
n PyCharm. You can create, build, and remotely launch your application in the IX20.
n Your preferred editor and
in the IX20.
IX20 User Guide
Enable service discovery
Allow remote access for web administration and
Disable shell
development.
manually transfer the application, install dependencies, and launch
Develop Python applications
(mDNS).
Configure SSH access, Use SSH with key
SSH.
access.
798