Digi IX20W-PR User Manual page 210

Interfaces
(config)> add network interface my_lan ipv4 dhcp_server advanced static_
lease end
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)>
See Configure a Local Area Network (LAN)
4. Set the MACaddress of the device associated with this static lease, using the colon-separated
format:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> mac 00:40:D0:13:35:36
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)>
5. Set the IP address for the static lease:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> ip 10.01.01.10
(network interface my_lan ipv4 dhcp_server advanced static_lease 0)>
Note The IP address here should be outside of the DHCP server's configured lease range. See
Configure a DHCP server
6. (Optional) Set a label for this static lease:
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> name label
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)>
7. Save the configuration and apply the change
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show current static IP mapping
To view your current static IP mapping:

Web
Log into the IX20 WebUI as a user with full Admin access rights.
1. On the main menu, click Status
2. Under Networking, click DHCP Leases.

Command line
IX20 User Guide
for information about creating a LAN.
for further information about the lease range.
Local Area Networks (LANs)
210