Table of Contents
Advertisement
Interfaces
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config network interface my_wan surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add network interface my_wan surelink actions end
(config network interface my_wan surelink actions 0)>
c. New actions are enabled by default. To disable:
(config network interface my_wan surelink actions 0)> enable false
(config network interface my_wan surelink actions 0)>
d. Create a label for the action:
(config network interface my_wan surelink actions 0)> label string
(config network interface my_wan surelink actions 0)>
e. Set the type of recovery action to reboot_device:
(config network interface my_wan surelink actions 0)> action reboot_
device
(config network interface my_wan surelink actions 0)>
n
n
7. Optional SureLink configuration parameters:
IX20 User Guide
o
up: The test will pass only if the referenced interface is up and passing its
own SureLink tests (if applicable).
o
down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
Set the number of failures for this recovery action to perform, before moving to the
next recovery action:
(config network interface my_wan surelink actions 0)> test_
failures int
(config network interface my_wan surelink actions 0)>
The default is 3.
Set the time to wait before the next test is run. If set to the default value of 0s, the
test interval is used.
(config network interface my_wan surelink actions 0)> override_
interval int
(config network interface my_wan surelink actions 0)>
Wide Area Networks (WANs)
114
Advertisement
Table of Contents
