Table of Contents
Advertisement
Services
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service snmp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to include additional firewall zones.
5. Set the name of the user that will be used to connect to the SNMP agent.
(config)> service snmp username name
(config)>
6. Set the password for the user that will be used to connect to the SNMP agent:
(config)> service snmp password pwd
(config)>
7. (Optional) Set the port number for the SNMP agent. The default is 161.
IX20 User Guide
eth1
eth2
loopback
modem
(config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config)>
Simple Network Management Protocol (SNMP)
ETH1
ETH2
Loopback
Modem
698
Advertisement
Table of Contents
