Digi IX20W-PR User Manual page 388

Default value: /network/bridge/lan
Current value: /network/bridge/lan
(config network bridge new_hotspot_bridge)>
ii. Add the appropriate device. For example, to add the Digi AP Wi-Fi access point:
(config network bridge new_hotspot_bridge)> add device end
/network/wireless/ap/digi_ap
(config)>
c. Type ... to return to the config prompt:
(config network bridge new_hotspot_bridge)> ...
(config)>
d. Create an interface for the bridge:
(config)> add network interface hotspot_bridge_interface
(config network interface hotspot_bridge_interface)>
e. Add the new bridge to the interface:
(config network interface hotspot_bridge_interface)> device
/network/bridge/new_hotspot_bridge
(config network interface hotspot_bridge_interface)>
f. Set an IP address for the interface.
Note This IP address is not the IP address of the hotspot. The hotspot IP address is
configured during hotspot configuration.
(config network interface hotspot_bridge_interface)> ipv4 address ip_
address/netmask
(config network interface hotspot_bridge_interface)>
g. Type ... to return to the config prompt:
(config network interface hotspot_bridge_interface)> ...
(config)>
5. Create a new hotspot:
(config)> add network hotspot new_hotspot
(config network hotspot new_hotspot)>
New hotspots are enabled by default.
IX20 User Guide
/network/wireless/ap/digi_hotspot_ap
Hotspot
388