Table of Contents
Advertisement
Interfaces
c. Ancillary DNS redirect is enabled by default, which means resolves all DNS requests to
the connected device and redirects HTTP traffic to the device's web administration page.
12. For Server type, select the type of server to use to pass the IP address through to the client.
13. If PPPoE server is selected for Server type:
a. Click to expand PPPoE server.
b. For Service name, type the name of service to offer to the client.
c. For Access concentrator name, type the name of the access concentrator to report to the
client. If no name is provided, the host name is used.
d. For Authentication method, select the authentication method used to connect to the
remote peer.
If an authentication method is selected, type the Username and Password required to
authenticate the remote peer.
e. (Optional) Click to expand Custom PPP configuration.
f. Custom PPP configuration is disabled by default. Click toggle on Enable.
g. Enable Override to override the default configuration and use only the custom
configuration file.
h. For Configuration file, type or paste configuration data using the format of a pppd
options file.
14. (Optional) Click to expand 802.1x to configure 802.1x port based network access control.
The IX20 can function as an 802.1x authenticator; it does not function as an 802.1x supplicant.
a. Click to expand Authentication.
b. Click Enable server to enable the 802.1x authenticator on the IX20 device.
c. Set the Reauth period.
15. Configure IPv4 settings:
a. Click to expand IPv4.
IPv4 support is enabled by default.
b. Set the Metric.
c. For Weight, type the relative weight for default routes associated with this interface. For
multiple active interfaces with the same metric, Weight is used to load balance traffic to
the interfaces.
d. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
e. Set the MTU.
f. For Use DNS, select one of the following:
n
n
n
g. See
Configure SureLink active recovery to detect WAN/WWAN failures
about configuring SureLink for active recovery.
IX20 User Guide
Always: DNS will always be used for this WAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
When primary default route: Only use the DNS servers provided for this interface
when the interface is the primary route.
Never: Never use DNS servers for this interface.
Local Area Networks (LANs)
for information
222
Advertisement
Table of Contents
