Ip Igmp Startup-Query-Count - Allied Telesis IE220 Series Manual

IGMP IGMP S C
AND NOOPING OMMANDS
- -
IP IGMP STARTUP QUERY COUNT

ip igmp startup-query-count

Overview Use this command to configure the IGMP startup query count for an interface. The
IGMP startup query count is the number of IGMP General Query messages sent by
a querier at startup. The default IGMP startup query count is 2.
Use the no variant of this command to return an interface's configured IGMP
startup query count to the default.
ip igmp startup-query-count <startup-query-count>
Syntax
no ip igmp startup-query-count
Default The default IGMP startup query count is 2.
Mode Interface Configuration for a VLAN interface.
To set the IGMP startup query count to 4 on vlan2, use the commands:
Example
awplus#
awplus(config)#
awplus(config-if)#
Related ip igmp last-member-query-count
commands
ip igmp startup-query-interval
C613-50644-01 Rev B
Parameter
<startup-query-count>
configure terminal
interface vlan2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Specify the IGMP startup query count, in the range
2-10.
ip igmp startup-query-count 4
1009