Save Captured Data Traffic To A File - Digi IX20-WAG4 User Manual

Diagnostics
Total Length
ID
Flags
Fragment Offset
TTL
Protocol
Checksum
Source IP Address
Dest. IP Address
TCP Header
Source Port
Destination Port
Sequence Number
Ack Number
Data Offset
Flags
Window
Checksum
Urgent Pointer
TCP Data
00 00 00 00 00 00
>
where capture_filter is the name of a packet capture configuration. See
capture for the network analyzer
To determine available packet capture configurations, use the ?:
> show anaylzer name ?
name: Name of the capture filter to use.
Format:
test_capture
capture_ping
> show anaylzer name

Save captured data traffic to a file

Data traffic is captured to RAM and when the device reboots, the data is lost. To retain the captured
data, first save the data to a file and then upload the file to a PC.
To save captured traffic data to a file, use the

Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX20 User Guide
: 40 bytes
: 15670 (0x3d36)
: Do not fragment
: 0 (0x0000)
: 128 (0x80)
: TCP (6)
: 0x14bc
: 10.10.74.130
: 10.10.74.72
: 52654
: 22
: 2756443999
: 3995064355
: 5
: ACK
: 2050
: 0xc740
: 0
for more information.
analyzer save command:
Analyze network traffic
......
Configure packet
792