Wi-Fi
c. Set the channel for the Wi-Fi radio:
(config)> network wifi radio wifi1 2400mhz channel value
(config)>
where value is:
n
n
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the Wi-Fi radio to support DFS channels in client mode
Dynamic Frequency Selection (DFS) is a mechanism for Wi-Fi connections to use 5 GHz frequencies
that are normally reserved for non-Wi-Fi proposes. Your TX54 can be configured to have one or more
Wi-Fi clients that can connect to external Wi-Fi access points that support DFS channels, in addition to
the non-DFS channels 36, 40, 44, 48, 149, 153, 157, 161, and 165. The Wi-Fi access point must also
support connections on these channels.
Note
If DFS functionality is enabled, any access points enabled on the TX54 device will not be started.
Required configuration items
Enable DFS support.
n
One or more configured Wi-Fi clients. See
n
details.
WebUI
TX54 User Guide
Configure the Wi-Fi radio to support DFS channels in client mode
For 2.4 GHz:
1 through 11
l
auto
l
For 5 GHz:
36
l
40
l
44
l
48
l
auto
l
Configure a Wi-Fi client and add client networks
for
218